Close

Search

Search Menu
Photonics Media Photonics Buyers' Guide Photonics EDU Photonics Spectra BioPhotonics EuroPhotonics Industrial Photonics Photonics Showcase Photonics ProdSpec Photonics Handbook
More News
share
Email Facebook Twitter Google+ LinkedIn Comments

  • Water Stream Detects Pollution Better

Photonics.com
Oct 2013
NAPLES, Italy, Oct. 15, 2013 — A microfluidic sensor with a novel design uses unconfined streams of water as a simple, cheap way to test for dangerous chemicals and bacteria in liquid.

The pollutant detector, developed in Italy within the framework of the research project ACQUASENSE, forgoes the walls of channels used in today's more advanced water testing devices, which can produce background noise that makes getting a clear reading difficult. Instead, it favors a narrow stream of water unconfined by tubes or pipes, with the water jet doubling as both the sample and the collection equipment.


Schematic of the technique used to detect contaminants. A laser beam is directed perpendicularly into the flow of water. Fluorescent light from contaminants in the water is carried away to be detected and analyzed. Courtesy of Gianluca Persichetti, IREA-CNR.


"The innovative aspect of this sensor is related to the simple and tricky way used to collect the light — a water stream," said Gianluca Persichetti of the Institute for Electromagnetic Sensing of the Environment (IREA), National Research Council, (CNR) in Italy.

Typical microfluidic detectors rely on narrow channels to hold and control the water samples with their fluorescing organic compounds. But the laser light that illuminates bacteria and chemicals in the water also shines on the channel walls, where it scatters and obscures the distinction between the fluorescing contaminants and their background. Wear and tear on the walls also weakens the reliability of measurements made using these instruments.


Close-up of the liquid jet sensor with the liquid jet formed (left) and without (right). Courtesy of Gianluca Persichetti, IREA-CNR.


Instead, Persichetti and his colleagues in the group led by Romeo Bernini decided simply to do away with them. In their new technique, they pump the water sample through a nozzle at 1.4 meters per second, producing a narrow stream that is less than a millimeter in diameter. Then they shine a UV laser onto the exposed jet of water. The fluorescent light produced by the pollutants and bacteria bounces around and is trapped inside the jet, which acts as a waveguide, channeling light through the stream.

The laser light is also source of a background noise that can cloud the signal, Persichetti said, so the amount of light that gets trapped in the jet was minimized by firing the laser beam at an angle perpendicular to the water stream.

After traveling 16 mm, the jet enters a small pipe containing an optical fiber, which collects the fluorescent light signals. The water is pumped back to recirculate through the nozzle, allowing the instrument to analyze even a small sample for an extended period of time.

The device was tested with varying amounts of some of the main pollutants of ground water - soil contaminants such as benzene, toluene, and xylene (together called BTX), and polycyclic aromatic hydrocarbons, which are hazardous, carcinogenic chemicals found in tar and petroleum. Persichetti and colleagues found that the device was extremely sensitive: It could detect pollutant levels even lower than those allowed by the Environmental Protection Agency (EPA). The instrument could also sense Bacillus subtilus, a harmless bacterium similar to the one that causes anthrax.

The current device is fitted with a spectrophotometer to measure the optical signatures of specific chemicals. To make the device even cheaper and smaller for future commercialization in water-safety testing, the researchers plan to replace the laser with an LED and to replace the spectrophotometer with a simpler and less expensive setup that would include a filter to remove unwanted background light, and a photodiode, which converts light into electricity, to detect the signal.

In addition to water-safety applications, Persichetti said, future instruments can be designed with more sophisticated sensors to distinguish between a variety of chemicals or bacterial cells for biological and medical research.

The paper, “High sensitivity UV fluorescence spectroscopy based on an optofluidic jet waveguide,” appears in Optics Express

For more information, visit www.osa.org



GLOSSARY
sensor
1. A generic term for detector. 2. A complete optical/mechanical/electronic system that contains some form of radiation detector.
spectrophotometer
An instrument for measuring spectral transmittance or reflectance.
Comments
Terms & Conditions Privacy Policy About Us Contact Us
back to top

Facebook Twitter Instagram LinkedIn YouTube RSS
©2016 Photonics Media
x We deliver – right to your inbox. Subscribe FREE to our newsletters.