Search
Menu
Gentec Electro-Optics Inc   - Measure With Gentec Accuracy LB

Fraunhofer, Philips Work to Optimize OLEDs

Facebook X LinkedIn Email
Organic LEDs (OLEDs) are seen as the basis for a new generation of lamps, but are still very expensive to process. The  Fraunhofer Institute for Laser Technology ILT and Philips are working to optimize these lamps by making them bigger, cheaper and more suitable for mass-production.


In a new process, extremely fine conductor paths can be applied to glass. (Image: Fraunhofer ILT)


An OLED consists of a sandwich layer structure — a flat electrode at the bottom, several intermediate layers on top as well as the actual luminescent layer consisting of organic molecules. The final layer is a second electrode made of a special material called ITO (indium tin oxide). Together with the lower electrode, the ITO layer has the job of supplying the OLED molecules with current and causing them to light up. The problem is, however, that the ITO electrode is not conductive enough to distribute the current uniformly across a larger surface. The consequence is that instead of a homogeneous fluorescent pattern, the brightness visibly decreases in the center of the surface luminaire.

“In order to compensate, additional conductor paths are attached to the ITO layer,” said Christian Vedder, project manager at Fraunhofer ILT. “These conductor paths consist of metal and distribute the current uniformly across the surface so that the lamp is lit homogenously.”

Normally the conductor paths are applied by energy-intensive evaporation and structuring processes, while only a maximum of ten percent of the luminous area may be covered by conductor paths.

Lumencor Inc. - ZIVA Light Engine 3-24 MR

“The large remainder including the chemical etchant has to be recycled in a complicated process,” said Vedder.

This is different in the new process from the researchers from the Fraunhofer ILT. Instead of depositing a lot of material by evaporation and removing most of it again, the scientists only apply precisely the amount of metal required. First of all they lay a mask foie on the surface of the ITO electrode. The mask has micrometer slits where later the conductive paths are supposed to be. On this mask the researchers deposit a thin film of metal made of aluminum, copper or silver — the metal the conductor path is supposed to be made of. Subsequently a laser passes over the conductor path pattern at a speed of several meters per second. The metal melts and evaporates while the vapor pressure makes sure that the melt drops are pressed through the fine slits in the masks on to the ITO electrode. The result is extremely fine conductor paths. At up to 40 µm, they are distinctly narrower than the 100 µm conductor paths which can be produced with conventional technology.

“We have already been able to demonstrate that our methods work in the laboratory,” Vedder said. “The next step is implementing this method in industrial practice together with our partner Philips and developing a plant technology for inexpensively applying the conductor paths on a large scale.”

The new laser process could be ready for practical application in two to three years.

For more information, visit:  www.ilt.fraunhofer.de 



Published: November 2010
Glossary
indium tin oxide
A material widely used as a transparent conductive coating.
luminaire
A complete unit containing a light source, globe, reflector, housing, socket and other necessary components for lighting.
BusinessChristian Vedderconductor pathsenergy-intensive evaporationEuropeflat electrodeFraunhofer ILTGermanyhomogenous fluorescent patternindium tin oxideindustriallampsLight Sourcesluminaireluminescent layer of organic moleculesOLEDsPhilipsResearch & TechnologyLEDs

We use cookies to improve user experience and analyze our website traffic as stated in our Privacy Policy. By using this website, you agree to the use of cookies unless you have disabled them.