Search Menu
Photonics Media Photonics Buyers' Guide Photonics Spectra BioPhotonics EuroPhotonics Vision Spectra Photonics Showcase Photonics ProdSpec Photonics Handbook

LED-Pumped Polymer Laser Emits at 568 nm

Facebook Twitter LinkedIn Email Comments
Technique may enable new generation of efficient visible lasers.

Breck Hitz

Semiconducting conjugated polymer materials are easy to fabricate into photonic devices, and their emission spans the visible spectrum. They would be attractive candidates for commercial lasers, but until now, they required pumping by another laser, an added complexity that was a barrier to further development.

Recently, however, researchers at the University of St. Andrews in the UK integrated a pump InGaN LED with a semiconducting polymer and observed visible lasing from the polymer.


Figure 1. The polymer laser is pumped by an InGaN LED. Courtesy of Ying Yang and Georgios Tsiminis, University of St. Andrews.

For the laser gain medium, they spin-coated a layer of semiconducting polymer that was several hundred nanometers thick onto a corrugated silica substrate. They added another polymer layer atop this structure to prevent contamination of the gain medium by water or oxygen. They then contacted the pump LED against the top of the assembly and positioned a dichroic mirror beneath it (Figure 2). The mirror served as both the output coupler (slightly less than 10 percent transmissive at 570 nm) and as a pump mirror to reflect the pump light for a second pass through the gain medium (98 percent reflective at 450 nm).


Figure 2. The LED pumped the semiconducting polymer ADS233YE. The fluorinatedpolymer CYTOP layer provided a transparent barrier to oxygen and water. Reprinted with permission of Applied Physics Letters.

First-order Bragg scattering from the corrugation on the silica substrate, which had a 355-nm period and 70-nm depth, provided horizontal distributed feedback for the laser resonator, while second-order scattering diffracted some of the circulating power to the dichroic-mirror output coupler. The gain medium itself was a thin high-index slab waveguide that supported the lowest-order transverse electric and magnetic modes, TE0 and TM0, respectively.

The scientists initially pumped the laser with an optical parametric oscillator rather than with the LED that is shown in Figure 2. They focused the 450-nm pump light to an ~1.7-mm spot on the top of the polymer and observed the narrow spectral peak indicating lasing at pump intensities above 200 W/cm2 when the pump light made a single pass through the gain medium, or 150 W/cm2 when it was reflected for a second pass.

The next step was to substitute the LED shown in Figure 2 for the optical parametric oscillator, but the commercial LED from Philips Lumileds of San Jose, Calif., could not supply the continuous 150 W/cm2 necessary to achieve laser threshold. When the researchers operated the LED in a pulsed mode, however, they observed a sharp emission peak at 568 nm emerging from the background photoluminescence at peak pump currents of more than 140 A (Figure 3a).


Figure 3. The emergence from background photoluminescence of a narrow peak at 568 nm provided strong evidence that the semiconducting polymer laser had reached threshold (a). Further evidence of lasing was provided by the sharp elbow in the output power at 568 nm, corresponding to oscillation of the TE0 mode in the slab waveguide (b). On the other hand, the TM0 mode at 555 nm did not reach threshold under LED pumping. Reprinted with permission of Applied Physics Letters.

This emission peak, together with the sharp elbow in the output power (Figure 3b), were a clear indication of lasing in the resonator’s TE0 mode. Although the researchers saw a secondary peak corresponding to lasing in the TM0 mode at 555 nm when pumping with the optical parametric oscillator, no such lasing occurred with LED pumping, as evidenced in Figure 3b.

Applied Physics Letters, April 23, 2008,163306.

Photonics Spectra
Jul 2008
visible spectrum
That region of the electromagnetic spectrum to which the retina is sensitive and by which the eye sees. It extends from about 400 to 750 nm in wavelength.
photonic devicesResearch & TechnologySemiconducting conjugated polymer materialsTech Pulsevisible spectrumlasers

back to top
Facebook Twitter Instagram LinkedIn YouTube RSS
©2020 Photonics Media, 100 West St., Pittsfield, MA, 01201 USA, [email protected]

Photonics Media, Laurin Publishing
x Subscribe to Photonics Spectra magazine - FREE!
We use cookies to improve user experience and analyze our website traffic as stated in our Privacy Policy. By using this website, you agree to the use of cookies unless you have disabled them.