Search Menu
Photonics Media Photonics Buyers' Guide Photonics Spectra BioPhotonics EuroPhotonics Vision Spectra Photonics Showcase Photonics ProdSpec Photonics Handbook

Laser Technique Aids Spintronics

Facebook Twitter LinkedIn Email Comments
Hank Hogan

A research group at Eindhoven University of Technology in Eindhoven, the Netherlands, and at IMEC vzw in Louvain, Belgium, has demonstrated an optical technique that could provide needed materials data for the development of spintronics, leading to the production of devices based on magnetic spin. Such devices promise advantages over their electronic analogs.

An optical technique promises to aid the development of spintronic devices. The graph indicates the periodic changes in the magnetization (ΔMz/Mz) of one element on a lithographically defined permalloy array, seen in an optical microscope image (inset). Courtesy of Maarten van Kampen.

For example, spintronics memory could store data without power, such as on a hard disk, but retrieve it rapidly, such as computer RAM. Before such gizmos appear, however, basic research needs to be done, including identifying methods to detect microscopic magnetic spin. The optical technique may satisfy this requirement.

It relies on a one-two laser punch. First, the researchers focused a 70-fs pulse of 780-nm radiation onto a 10-µm-wide area of the film being characterized. The pulse, which had a power of about a nanojoule, induced rapid, localized heating and a corresponding change in magnetization. A second laser pulse, 100 times weaker than the first, then enabled the researchers to probe the magnetization by measuring the change in the polarization of the reflected radiation.

In their experiments, the scientists discovered that the magnetization circled around its undisturbed state like a top as the material cooled. The results indicate that this magnetic precession may be probed from 10 ps to several nanoseconds after the initial pump pulse. Continued probing provided additional information.

Maarten van Kampen, a member of the Dutch team, noted that the wavelength of the technique is not critical and that greater spatial resolution, even submicron resolution, is possible. Because the technique is optical, there is no contact, and local characteristics can be probed. On the other hand, the material must be reflective and reachable by the pulse. It also is not possible to switch the material's magnetic state using this method.

The team sees several directions for the research, including investigating means to improve both the optical and magnetic techniques. Van Kampen said that the group might seek to combine magnetic and optical excitation into a thermally assisted switching technique.

Photonics Spectra
Aug 2002
MicroscopyResearch & TechnologyTech Pulse

back to top
Facebook Twitter Instagram LinkedIn YouTube RSS
©2020 Photonics Media, 100 West St., Pittsfield, MA, 01201 USA, [email protected]

Photonics Media, Laurin Publishing
x Subscribe to Photonics Spectra magazine - FREE!
We use cookies to improve user experience and analyze our website traffic as stated in our Privacy Policy. By using this website, you agree to the use of cookies unless you have disabled them.