Search
Menu
Hamamatsu Corp. - Earth Innovations LB 2/24

Solar design triumphs through thick and thin

Facebook X LinkedIn Email
Marie Freebody, Contributing Editor, [email protected]

The quest for high power-conversion efficiency in most thin-film solar cells has often been hindered by the “thick and thin” challenge, in which a cell must be thick enough to collect a sufficient amount of light, yet thin enough to extract current. Now a novel solar cell devised by physicists at Boston College in Chestnut Hill and inspired by the coaxial cable resolves this dilemma by being both optically thick and electrically thin.


This is an electron microscope image of a nanocoax solar cell array comprising 2-μm-tall metal nanopillars conformally coated with 100 nm of amorphous silicon and 70 nm of indium tin oxide. The nanocoaxes in the array are spaced 900 nm apart (see scale bar). Images courtesy of Boston College.


“The challenge has to do with the desire to make a highly optically absorbing cell that is simultaneously highly efficient at extracting electric charge as current,” said one of the creators, Michael Naughton, a professor of physics at the college. “In simple terms, a thick cell achieves the former, while a thin cell, the latter. Our nanocoax design achieves both, which has intrinsic advantages in terms of cost, so long as good efficiency can be achieved.”

The so-called nanocoax solar cell boasts greater efficiency than any previously designed nanotech thin-film (noncrystalline) solar cell. As reported in the July 2010 issue of Physica Status Solidi, the nanocoax cells, made with amorphous silicon, yield power-conversion efficiency in excess of 8 percent, and similar cells yielded efficiencies of more than 9.6 percent.


A nanocoax solar cell array is shown at different magnifications. On the left is a completed cell array, while the middle image illustrates how a focused-ion beam is used to mill out a section of the array, exposing the constituent components. On the right is an expanded section that has been milled by a focused ion beam.


Naughton also reports that, since publication, his team – in collaboration with Solasta Inc. of Newton, Mass., and the Neuchatel Institute of Microengineering at the EPFL in Neuchatel, Switzerland – has achieved even greater initial efficiency of more than 10.5 percent, as certified by the National Renewable Energy Laboratory.

Deposition Sciences Inc. - Difficult Coatings - MR-8/23

Many solar cells are based on crystalline semiconductors due to their superior energy-conversion efficiency compared with noncrystalline thin-film cells. The problem is that the dominant material (crystalline silicon) must be relatively thick to collect light. On the other hand, noncrystalline materials such as amorphous silicon are strongly absorbing but less efficient electrical conductors.

To overcome the “thick and thin” barrier, Naughton and his colleagues started by separating the optics from the electronics by forming an array of vertically oriented nanocoaxes. In each nanoscale coaxial wire in the array, an inner and outer metal surround a dielectric medium, just as in a conventional coaxial wire. The difference here is that the dielectric is a photovoltaic material such as silicon. “In such a wire, light collection is governed by the height (length) of the nanocoax, while charge (electron and hole) extraction is governed by the thinness of the photovoltaic in the coax annuli, which can be quite thin and still absorb light,” he said.

The result is a geometry that separates the “photo” from the “voltaic” and enables high energy-conversion efficiency using thinner, less expensive thin-film materials.

“The nanocoax configuration achieves efficiency more than 50 percent higher than a conventionally prepared ‘planar’ thin-film silicon cell,” Naughton said.

Solar cells of this type (amorphous silicon) face a major problem known as the Staebler-Wronski effect, in which light-induced degradation damages the conversion efficiency of the cell. The team says the ultrathin nature of the nanocoax cell reduces this destructive effect because the nanocoax architecture spatially distributes incident light in such a way that the local intensity per unit volume is less than in a planar cell.

The nanocoax concepts and the nanocoax solar cell array were invented by professors Krzysztof Kempa, Michael Naughton and Zhifeng Ren, and by Drs. Yang Wang and Jakub Rybczynski, all in the department of physics at Boston College.

Published: September 2010
Glossary
coaxial cable
A type of cable made up of two conductors; one conductor is inside of and concentric with the other.
nano
An SI prefix meaning one billionth (10-9). Nano can also be used to indicate the study of atoms, molecules and other structures and particles on the nanometer scale. Nano-optics (also referred to as nanophotonics), for example, is the study of how light and light-matter interactions behave on the nanometer scale. See nanophotonics.
thin film
A thin layer of a substance deposited on an insulating base in a vacuum by a microelectronic process. Thin films are most commonly used for antireflection, achromatic beamsplitters, color filters, narrow passband filters, semitransparent mirrors, heat control filters, high reflectivity mirrors, polarizers and reflection filters.
amorphous siliconBoston Collegecoaxial cableenergyEPFLGreenLightJakub RybczynskiKrzysztof KempaMarie Freebody.Michael NaughtonMicroscopynanonanocoaxNational Renewable Energy LaboratoryNaughtonNeuchatel Institute of MicroengineeringPhysica Status Solidisolar cellsSolasta Inc.thick and thin challengethin filmZhifeng Ren

We use cookies to improve user experience and analyze our website traffic as stated in our Privacy Policy. By using this website, you agree to the use of cookies unless you have disabled them.