Search Menu
Photonics Media Photonics Buyers' Guide Photonics EDU Photonics Spectra BioPhotonics EuroPhotonics Industrial Photonics Photonics Showcase Photonics ProdSpec Photonics Handbook
More News
Email Facebook Twitter Google+ LinkedIn Comments

Vibrating Nanorods Measure Thin Films
Dec 2010
ITHACA, NY, Dec. 20, 2010 — Much like a tuning fork, researchers are using lasers to vibrate cantilevers to determine their resonant frequency, a tool that is helping to verify the density of thin films. The method, known as atomic layer deposition, is becoming increasingly important to in constructing microcircuits because their physical characteristics often determine their electronic behavior as well as their resistance to wear.

The researchers from Cornell and Tel Aviv University have shown that tiny resonant cantilevers — silicon rods anchored at one end, like a tiny diving board — can determine the density of a film and its Young's modulus, a measure of resistance to bending. The method offers several advantages over other methods of measuring these characteristics of thin films, the researchers said, and can be used by any researchers with access to nanofabrication capabilities comparable to those at the Cornell Nanoscale Facility.

The work was reported in the Journal of Applied Physics by Cornell research associate Rob Ilic, Slava Krylov, senior lecturer at Tel Aviv University and former visiting professor at Cornell, and Harold Craighead, the C.W. Lake Jr. Professor of Engineering at Cornell.

Schematic illustration of the measurement of in-plane and out-of-plane vibrational modes of a silicon cantilever. Modulated blue laser excites the NEMS structure and laser interferometry monitors the cantilever motion. Spectral characteristics of the in-plane (blue) and out-of plane (red) modes change when a thin-film coating, shown in green, is applied. (Images: Rob Ilic/Craighead Group)

Cornell researchers have previously used tiny vibrating cantilevers just a few nanometers (billionths of a meter) thick to detect the mass of objects as small as a virus. Just as a thick guitar string vibrates at a lower note than a thinner one, adding mass to a vibrating rod changes its frequency of vibration. Coating the rod with a thin film adds detectable mass, and from the mass and thickness of the film, density can be determined.

The film also changes the cantilever's resistance to bending. To separate out this characteristic, the researchers compared in-plane (side to side) and out-of-plane (up and down) vibrations. The resistance to bending in different directions is noticeably different when the vibrating rod is wide and thin. When the cross-section of the rod is square, there is no difference between up and down and side-to-side movement.

Scanning electron micrographs of silicon cantilevers 8 µm long and 75, 300 and 800 nm wide.

To test their idea, the researchers fabricated a variety of cantilevers six to 10 µm long, 45 nm thick and with widths varying from 45 nm to 1 µm. In various experiments, they applied films of aluminum, aluminum nitride and hafnium from 21.2 to 21.5 nm thick to the surface of the cantilevers.

A laser beam focused on the base of a cantilever supplies energy to set it vibrating, and another laser aimed at the end measures the vibration. Like a tuning fork, each rod has a resonant frequency at which it vibrates, and that depends on the dimensions and physical characteristics of the device. Comparing the resonant frequency and some of its harmonics before and after a film was applied enabled the researchers to calculate the density and Young's modulus of the film.

Over many experiments, the calculations agreed well with theoretical predictions and characteristics of films measured by other methods. Some aspects of the method of fabricating the nanocantilevers could affect the results, the researchers found, but they said accuracy could be improved.

The work was supported by DARPA, the National Science Foundation and the state of New York.

For more information, visit: 

Americasatomic layer depositionBasic SciencecantileversCornellDARPAHarold Craigheadin-plane vibrationsmicrocircuitsnanonanocantileversNanorodsNational Science FoundationNew Yorkout-of-plane vibrationsResearch & Technologyresonant frequencyRob Ilicsilicon rodsSlava KrylovTel Aviv UniversityTest & Measurementthin filmsvibrating cantileversYoungs moduluslasers

Terms & Conditions Privacy Policy About Us Contact Us
back to top
Facebook Twitter Instagram LinkedIn YouTube RSS
©2018 Photonics Media, 100 West St., Pittsfield, MA, 01201 USA,

Photonics Media, Laurin Publishing
x We deliver – right to your inbox. Subscribe FREE to our newsletters.
We use cookies to improve user experience and analyze our website traffic as stated in our Privacy Policy. By using this website, you agree to the use of cookies unless you have disabled them.