Search
Menu
CASTECH INC - New Building the Bridge of Light

Intricate Experiment Reveals Cause of LED Droop

Facebook X LinkedIn Email
SANTA BARBARA, Calif., April 24, 2013 — The future looks bright for alternative lighting now that scientists have solved the mystery that causes LEDs to “droop” in efficiency at high currents.

The phenomenon known as LED droop has intrigued researchers for years. In 2011, University of California, Santa Barbara, professor Chris van de Walle and colleagues theorized that a complex nonradiative process known as Auger recombination was behind nitride semiconductor LED droop, whereby injected electrons lose energy to heat by collisions with other electrons, rather than emitting light. (See: LED Efficiency Puzzle Reportedly Solved)

Now, a definitive measurement of this complex process has been accomplished by James Speck and Claude Weisbuch of UCSB, in collaboration with colleagues at École Polytechnique in France. The achievement, which could help optimize cost per lumen, could put the technology back into the spotlight as a viable replacement for incandescent bulbs for residential and commercial lighting.

Researchers at UCSB and École Polytechnique have confirmed that the Auger recombination theory is responsible for LED droop.
Researchers at UCSB and École Polytechnique have confirmed that the Auger recombination theory is responsible for LED droop. This LED emits light under forward bias in an ultrahigh-vacuum chamber, allowing simultaneous electron emission energy. Courtesy of École Polytechnique.


Zurich Instruments AG - Boost Your Optics 1-24 MR
The experiment used an LED with a specially prepared surface that permitted the investigators to directly measure the energy spectrum of electrons emitted from the LED. The results unambiguously showed a signature of energetic electrons produced by the Auger process.

“This was a very complex experiment — one that illustrates the benefits of teamwork through both an international collaboration and a DOE Energy Frontier Research Center,” said Weisbuch, distinguished professor of materials at UCSB’s Center for Energy Efficient Materials, an Energy Frontier Research Center sponsored by the Department of Energy, and a faculty member at École Polytechnique in Paris.

Knowledge from this study could result in new ways to design LEDs that will have significantly higher light emission efficiencies. Replacing incandescent and fluorescent lights with LEDs in the US could save electricity equal to the total output of 50 1-GW power plants, according to the Department of Energy.

“Rising to this potential has been contingent upon solving the puzzle of LED efficiency droop,” said Speck, professor of materials and the Seoul Optodevice Chair in Solid State Lighting at UCSB. “These findings will enable us to design LEDs that minimize the nonradiative recombination and produce higher light output.”

The study appeared in Physical Review Letters

For more information, visit: www.ucsb.edu

Published: April 2013
AmericasLEDsConsumerEcole PolytechniqueLED droopLight SourcesResearch & TechnologyUCSBUniversity of California Santa Barbara

We use cookies to improve user experience and analyze our website traffic as stated in our Privacy Policy. By using this website, you agree to the use of cookies unless you have disabled them.