A microscopic cloak made of graphene could change the way bacteria and other cells are imaged. Vikas Berry of Kansas State University and his research team are wrapping bacteria with graphene to address challenges with imaging bacteria under electron microscopes. Berry’s method creates a carbon cloak that protects the bacteria, allowing them to be imaged at their natural size and increasing the image’s resolution. Graphene is a sheet of carbon only one atom thick, which gives it several important properties. “Although only an atom thick, graphene does not allow even the smallest of molecules to pass through,” Berry said. “Furthermore, it's strong and highly flexible, so it can conform to any shape.” Wrapping bacteria in graphene enhances scientists’ ability to image their biological functions. (Image: Kansas State University) The group has been researching graphene for three years, and Berry recently saw a connection between graphene and cell imaging research. Because graphene is impermeable, he decided to use the material to preserve the size of bacterial cells imaged under high-vacuum electron microscopes. The current challenge with cell imaging occurs when scientists use electron microscopes to image bacterial cells. Because these microscopes require a high vacuum, they remove water from the cells. Biological cells contain 70 to 80 percent water, and the result is a severely shrunken cell. As a result, it is challenging to obtain an accurate image of the cells and their components in their natural state. But Berry and his team created a solution to the imaging challenge by applying graphene. The graphene protects the bacteria from losing water so they don’t shrink under the high vacuum. This provides a microscopic image of the cell at its natural size. The carbon cloaks can be wrapped around the bacteria using two methods. The first method involves putting a sheet of graphene on top of the bacteria, much like covering up with a bed sheet. The other method involves wrapping the bacteria with a graphene solution, where the graphene sheets swaddle the bacteria. In both cases, the graphene sheets were functionalized with a protein to enhance binding with the bacterial cell wall. Under the high vacuum of an electron microscope, the wrapped bacteria did not change in size for 30 min, giving scientists enough time to observe them. This is a direct result of the high strength and impermeability of the graphene cloak, Berry said. Graphene's other extraordinary properties enhance the imaging resolution in microscopy. Its transparency to electrons enables clean imaging of the cells. Since graphene is a good conductor of heat and electricity, the local electronic charging and heating are conducted off the graphene cloak, giving a clear view of the bacterial cell wall. Unwrapped bacterial cells appear dark with an indistinguishable cell wall. "Uniquely, graphene has all the properties needed to image bacteria at high resolutions," Berry said. "The project provides a very simple route to image samples in their native wet state." The process has potential to influence future research. Scientists have always had trouble observing liquid samples under electron microscopes, but using carbon cloaks could allow them to image wet samples in a vacuum. Graphene's strength and impermeability ensure that wrapped cells can be easily imaged without degrading them. Berry said it might be possible in the future to use graphene to keep a bacterium alive in a vacuum while observing its biochemistry under a microscope. The research also paves the way for enhanced protein microscopy. Proteins act differently when they are dry and when they are in an aqueous solution. So far, most protein studies have been conducted in dry phases, but Berry's research may allow proteins to be observed more often in aqueous environments. The research results appear in a recent issue of Nano Letters. For more information, visit: www.k-state.edu