Photonics HandbookTechnology News

CMOS-Compatible Photodetector Spurs Possibilities in e-SWIR Band

Facebook X LinkedIn Email
High-bandwidth germanium-tin (GeSn) photodetectors, developed by a team at Polytechnique Montréal to support CMOS-compatible technologies in the extended shortwave infrared (e-SWIR) wavelength, could open the way for applications in ultrafast spectroscopy, next-generation optical communications, artificial intelligence, and other emerging areas.
Schematic of the TRS setup to measure emission from the SWIR LED or ps supercontinuum laser. In the upper-left corner is an SEM image and schematic of typical multi-layer GeSn thin-films grown on a silicon substrate. In the upper-right-corner is an example of an interferogram for the supercontinuum laser showing the burst peak and the pulse, temporal-wise waveform as recorded by oscilloscope. A Matlab code was used to fast Fourier transform (FFT) the interferogram into the time-resolved spectrum (with rainbow color) shown at the bottom. Courtesy of M.R.M. Atalla, S. Assali, S. Koelling, A. Attiaoui, and O. Moutanabbir, École Polytechnique de Montréal.
Schematic of the TRS setup to measure emission from the SWIR LED or picosecond supercontinuum laser. In the upper left is an SEM image and schematic of typical multilayer GeSn thin-films grown on a silicon substrate. In the upper right is an example of an interferogram for the supercontinuum laser showing the burst peak and the pulse, temporal-wise waveform as recorded by oscilloscope. A MATLAB code was used to fast Fourier transform the interferogram into the time-resolved spectrum (with rainbow color) at the bottom. Courtesy of M.R.M. Atalla et al., École Polytechnique de Montréal.
Specifically, high-speed photodetectors that operate at room temperature in the e-SWIR spectral range are needed to implement applications including high-resolution lidar, time-resolved spectroscopy, environmental monitoring of greenhouse gases, and optical tomography.

“High-speed e-SWIR photodetectors are also needed in night vision, imaging, and free-space communication,” researcher M.R.M. Atalla said. The developed photodetector supports these applications, as well as manufacturability.

“We expect that the bandwidth of these GeSn photodetectors will exceed a few tens of gigahertz as the diameter of the device is further reduced,” Atalla said. “This will stimulate the development of a plethora of cost-effective, silicon-integrated technologies where high speed is needed.”

To develop high-frequency, silicon-integrated detectors, the researchers grew all-GeSn PIN heterostructures on silicon wafers using a germanium virtual substrate in a low-pressure chemical vapor deposition reactor. The step-graded growth process enabled the researchers to tailor the strain and content in the detector’s layers and ensure that it covered the entire e-SWIR range. Using atom probe tomography, the team inspected the quality and structural properties of the GeSn material. The atomic-level study revealed the high crystalline quality of the device stacks and confirmed that there was no occurrence of tin clustering despite its out-of-equilibrium content.

The team fabricated vertical, top-down PIN photodetectors in various diameters in the 20- to 160-µm range. The researchers then used plasma etching to create a double mesa structure to reduce the contact pads’ capacitance.

The photodetector exhibited 0.3 A/W responsivity at the telecom wavelength of 1.55 µm, with a broadband spectral responsivity spanning the visible to e-SWIR wavelength range and a high bandwidth of 7.5 GHz at a bias of 5 V. The relative spectral responsivity of the GeSn photodetectors was measured using Fourier transform infrared (FTIR) spectroscopy. The researchers calibrated the data they obtained using an extended indium-gallium-arsenide (InGaAs) commercial detector with a cutoff of 2.6 µm.

To demonstrate the device’s potential to support silicon-compatible applications, the researchers integrated the GeSn photodetector into a time-resolved spectroscopy (TRS) application. The photodetector was used as a receiver in a time-resolved electroluminescence setup to probe the emission and extract the carrier lifetime from a 2.35-μm commercial e-SWIR LED.

In addition to demonstrating time-resolved electroluminescence, the researchers showed that the e-SWIR high-speed photodetectors could be used with TRS to investigate transient biophysical and chemical processes. They integrated the GeSn photodetectors into a FTIR step-scan measurement with a picosecond ultrashort pulse supercontinuum laser as a light source. The high-speed detectors identified pulse duration, intensity, and spectral distribution of the pulsed supercontinuum laser using the FTIR spectrometer and reached a temporal resolution in the picosecond range at wavelengths up to 2.5 µm.

“It was the low bandwidth of e-SWIR detectors based on III-V materials that limited the time-resolved spectroscopy to nanosecond temporal resolution,” Atalla said. “The high-bandwidth, group IV GeSn photodetectors make picosecond-range spectroscopy possible.”

The researchers said that time resolution became a bottleneck, as the events under study occurred on a timescale of less than a few hundreds of nanoseconds. They implemented various interferometric and noninterferometric TRS techniques to increase the time resolution. Noninterferometric techniques can achieve femtosecond time resolution; however, their spectral resolution is limited to a few hundred nanometers in the mid-infrared (MIR) wavelength range. Interferometric techniques can measure the entire spectrum at once, but they are limited to the speed of the scanning mirror (rapid scan) or the rise time of the MIR detector (step scan).

FTIR step-scan TRS offers several advantages, the researchers said, including ultrawide spectral range, high resolution and sensitivity, modest equipment cost, and ease of use. Since IR detectors with a cutoff above 2.3 µm do not operate at a high bandwidth, interferometric techniques are limited to the nanosecond time resolution range. However, the high-bandwidth GeSn photodetector can surpass this temporal resolution barrier.

The research was published in ACS Photonics (

Published: May 2022
A photodetector, also known as a photosensor or photodiode, is a device that detects and converts light into an electrical signal. Photodetectors are widely used in various applications, ranging from simple light sensing to more complex tasks such as imaging and communication. Key features and principles of photodetectors include: Light sensing: The primary function of a photodetector is to sense or detect light. When photons (particles of light) strike the active area of the photodetector,...
artificial intelligence
The ability of a machine to perform certain complex functions normally associated with human intelligence, such as judgment, pattern recognition, understanding, learning, planning, and problem solving.
The study and utilization of interference phenomena, based on the wave properties of light.
Lidar, short for light detection and ranging, is a remote sensing technology that uses laser light to measure distances and generate precise, three-dimensional information about the shape and characteristics of objects and surfaces. Lidar systems typically consist of a laser scanner, a GPS receiver, and an inertial measurement unit (IMU), all integrated into a single system. Here is how lidar works: Laser emission: A laser emits laser pulses, often in the form of rapid and repetitive laser...
Research & TechnologyeducationphotodetectorspectroscopyImagingAmericasMaterialsCommunicationsartificial intelligenceWafersnight visionextended SWIRSWIRIRinterferometrySensors & Detectorsoptical componentsoptical deviceslidarsilicon photonicsTechnology News

We use cookies to improve user experience and analyze our website traffic as stated in our Privacy Policy. By using this website, you agree to the use of cookies unless you have disabled them.